Description
So sophisticated!
This product adds another dimension to your work, and is very cost effective! I am selling in 1 kg bags.
Preparing your project:
- Because of the fluid nature of the product, seepage can occur (as shown), so take care to glue well.
- Clean excess glue away well, as thick deposits may show through the finished layer.
- Projects should have an edge to stop product flowing off your substrate:
- You can create a temporary dam with a few layers of painters tape, or some blue-tac;
- create a tiled edge (grouted);
- Use a frame; or
- use one of our Walled Boards, as I did. Available here.
- Porous substrates should be primed prior to application.
- Make sure your work is positioned on a LEVEL surface where it can remain undisturbed until set (approx. 10 mins at 23ºC).
- As a cementitious product, a P95 mask and gloves should be used when handling dry material.
- Very low VOC
- Can be coloured:
- Add colour to dry powder, and stir well.
- Adding pigment will make the product dry out more quickly, so you should mix it a bit wetter (but not too much)
- The product is white.
Usage:
- Mix the required amount into clean cold water. Ratio is 215-220mls water per kg (depending on temp)
- Stir smoothly. Do not shake, as this introduces air bubbles.
- apply immediately after slaking.
- Pour slowly onto your piece
- use a poker, pick or toothpick to encourage the mixed product to flow into corners and small areas.
- Leave to set, undisturbed until set (approx. 10 minutes).
- Clean utensils straight away, or dispose of responsibly.
Technical information:
Available in 1 kilo bags. This requires approximately 215-220mls water per kg (depending on temp). You need to have a pourable consistency.
- This is NOT an adhesive!
- 2 minutes initial slake, stir and let sit for a further 30 seconds
- 20 minute working time (pot life) at 23ºC.
- 12 months shelf-life (stored in dry, elevated location).
- 2 hour Initial set time at 23ºC.
- 6 hours to Full cure.
- Internal use only
- Non-submersible.
- Not recommended for locations subject to vibration.
- Product is porous.
NOTE: Colours may render differently depending on your monitor and settings.
Reviews
There are no reviews yet.